Connecting your laptop to the iLive network
____________________________________________________
Each device on the network must have a unique IP address with the same
Subnet mask. When you connect a laptop and wireless router they must have
unique IP addresses compatible with the iLive. The iLive default (reset)
addresses are:
Default MixRack IP address = 192.168.1.1
Default Surface IP address = 192.168.1.2
Default TouchScreen IP address = 192.168.1.3
Default xDR-16 Expander IP address = 192.168.1.20
Default Subnet Mask = 255.255.255.0
Wired - For stand-alone wired connection to the iLive plug a standard CAT5
network cable between the laptop Network (LAN) port and any iLive
NETWORK socket. Do not remove the usual network connection between the
Surface and MixRack. Set a compatible static IP address for your laptop LAN
port. Do not use DHCP for wired connection. For example:
Laptop LAN port IP address = 192.168.1.10
Laptop LAN port Subnet Mask = 255.255.255.0
Wireless - Plug a wireless router (wireless access point) into any iLive
NETWORK socket using a CAT5 cable. Use the laptop Wireless connection
to connect to the iLive via the router.
Wireless routers have an IP address to identify them on the network. This
address is also used to access their settings. Some routers default to
192.168.1.1 which conflicts with the default iLive MixRack address. In this
case change the address of the router before plugging it in to the iLive
network. Its address must be 192.168.1.nnn where nnn is the unique address
number different to that of the iLive and other devices on the network. Refer
to your wireless router guide for setup instructions. For example:
Wireless router IP address = 192.168.1.254
Wireless router Subnet Mask = 255.255.255.0
Check that the router is set for DHCP operation so that it automatically
allocates IP addresses to other DHCP enabled devices on the network, in this
case the laptop. Most wireless routers have DHCP enabled by default. Your
laptop wireless connection should be set for DHCP to automatically receive its
address from the router. Check that the router DHCP address range (scope)
is restricted to avoid conflict with the iLive and other connected devices with
static IP addresses. We recommend:
Wireless router = DHCP enabled
Start IP address = 192.168.1.100
End IP address = 192.168.1.200
(25 paginas)
(26 paginas)
(34 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales