
ALLEN&HEATH iLive Release Notes V1.94 Iss.1 Page 2 of 7
Libraries added: Dynamic EQ MB Comp3 MB Comp4
Bass Fix Guitar Cntrl IEM Glue
DynEQ Flat Honky Bass Keys Helper
Guitar Fix IEM Help Kit Distress
Kick Help Mix Tighten Multi4 Flat
Off Mic Boost Multi3 Flat Vox Fix it
Vocal Fix Vocal
Issues fixed:
Issue 1163 - In rare situations the TouchScreen could freeze for a while after selecting FX
and recalling large Scenes.
Issue 983 – Adding channels into a Gang would not update in Editor.
Issue 996 – IEM or Wedge monitor select not working in Editor.
Issue 997 – MIDI control of stereo Auxes in Editor would not update some controls.
Issue 971 – Channel selection in Editor was slower than it was in previous version V1.83.
Issue 578 - With an MMO card fitted to Port B of the modular surface, the audio including that
mapped to Aviom™ could be distorted and not correctly routed from the Port A link CH33 to
62. This has been fixed. For more information on using and patching the MMO card please
refer to the M-MMO card instructions document AP7654 issue 4 or higher which can be
downloaded from www.allen-heath.com.
Issue 585 – Plugging a ME-1 directly into ACE card Link 2 could result in the Link 2 Error
indicator remaining on.
Issue 572 – Can select but unable to deselect Aux mixes using SoftKeys when there is no
Main mix configured (monitor application).
Issue 1022 – Sometimes the TouchScreen PEQ curve would not redraw correctly when
changing channels.
Several other minor issues also fixed.
iLive firmware V1.9 - New features and improvements:
Support for the new fixed format iLive AES Digital Out option: One or more audio cards (8 in 4
out) in fixed format iDR MixRacks and the xDR-16 expander running V1.9 firmware can be replaced
with a new card that provides two AES output sockets (4 channels of digital output) instead of the four
analogue line outputs. Fixed format MixRacks can be ordered with one AES-Out card fitted, or an
option kit ordered to replace one or more cards in an existing MixRack.
Note The card should be fitted to an iLive rack that is already running V1.9 firmware. If the user fits
the card to a rack currently at V1.8 or lower the system will not boot. The card will need to be
disassembled from the rack and the system firmware updated to V1.9 before reassembling the card
into the rack.
Enhancements to the GEQ: The third octave graphic equaliser available on each of the 32 mix
outputs now has 28 bands with the addition of 31, 40 and 50Hz bands. A frequency response curve
and RTA display of the PAFL signal is included in the GEQ screen. A GEQ Mode button is added
providing a choice of one of four Graphic EQ models.
Comentarios a estos manuales