
iLive M-DANTE Option Instructions 5 AP8340 issue 2
Connections and indicators
Primary Port Gigabit Ethernet, Locking
EtherCon RJ45 connector. The main port.
Connect to the Primary port on another
Dante equipped device to link the devices
directly. Connect to a Gigabit switch to
connect multiple Dante enabled devices.
Connect to the Ethernet port on a PC or
Mac to allow audio recording or playback
via the Dante Virtual Soundcard.
Secondary Port Gigabit
Ethernet, Locking Ethercon
RJ45 connector. Independent
network that can be used for
dual redundant connection.
See Note 1 below.
Control Network
Primary
Secondary
Lnk/Act
GigE
Lnk/Act
ALLEN
Lnk/Act
&
HEATH
Control Network Gigabit Ethernet, RJ45
connector. Can be used to connect a
computer running Dante Controller for setting
up the network. See Note 2 below.
Link status Flashes to
indicate network
activity.
Link status One LED
indicates network
activity. The other
indicates that a Gigabit
Ethernet link has been
established.
Important Notes regarding Release 1 Dante firmware (version 3.4.x):
Note 1 Release 1 does not currently support the Secondary connection dual
redundant link. This feature will be introduced in Release 2 due shortly.
Note 2 Release 1 does not currently support a mix of Gigabit and Fast
Ethernet (100 Mbit) on its ports. Use Gigabit network devices including the
switch and computers throughout the Dante network. Do not bridge the 100
Mbit iLive Network to Dante using Release 1 firmware.
Note 3 Do not use the Control Network port for recording. This port is
intended for connecting a computer running Dante Controller. Use the
Primary port or a port on a Gigabit switch for the recording as shown in the
diagrams later in this guide.
A Firmware Update application will be available from Audinate when a new
version of Dante firmware is released.
Please also read the Known Issues and Brooklyn II Release Notes on the
Audinate web site:
www.audinate.com/allen-heath/ilive/M-DANTE/BrooklynII
Comentarios a estos manuales